Re-Connect Cables - Asus Terminator K7 User Manual

2.9 Re-connect Cables

You may have disconnected some cables when you were installing
components. You must re-connect these cables before you replace
the chassis cover.
2.9.1 Front Panel Cables
The figures below show the front panel cables with corresponding
instructions on where to connect them. You must re-connect these
cables before replacing the chassis cover.
Power Switch
Power LED
Line Out / Mic
USB Connector (USB2P)
1. Connect the power switch and power LED cables to their
respective leads in the PANEL connector on the motherboard.
2. Connect the HDD LED cable to the 2-pin lead marked IDELED.
3. Connect the Line Out/Mic cable to the FLOUT/MIC2 connector
on the motherboard, matching the red pin stripe with Pin 1.
4. Connect the USB2P cable to the USB1 connector on the
motherboard, matching the red pin stripe with Pin 1.
28
HDD LED
Chapter 2: Basic Installation