USC LPV100 Operator's Manual page 6

This is the stopping of machine motion by reducing the electrical com-
mand signal to
Electrocution accidents are most likely to occur during maintenance of
the electrical system or when working on or near exposed high volt-
age wiring. This hazard does not exist when the electrical power has
been disconnected, properly locked, and tagged out.
Page 6
TD-09-06-1064 LPV 100 SEED TREATER
CONTROLLED STOP
0 (zero) once the stop signal has been recognized.
HAZARD REVIEW
Electrocution Hazard
Automatic Start Hazard
This equipment may be controlled by an automated system
and may start without warning. Failure to properly disconnect,
lockout, and tagout all energy sources of remotely controlled
equipment creates a very hazardous situation and could
cause injury or even death. PLEASE STAY CLEAR AND BE
ALERT.