USC LPV100 Operator's Manual page 33

• Check and tighten wire connections.
• Check quick connects on bottom of control panel.
• Check to see if starters and/or overloads are tripped.
• Check to see if relays, timers and/or breakers are tripped.
• Check and set the proximity switches. (page 31).
• Check quick connects on end of Auxiliary cord.
• Check relay and fuse holder.
• Check power cords for cuts or frays and ensure ground is present.
• Remove drum guards and inspect all welds and structural components
on the frame and drum for bends, cracks and damage.
• Inspect pillow block bearings and grease every 40 hours of operation.
• Inspect drive wheels for unordinary wear and set screws for tightness.
• Inspect the Neoprene idler wheels for unordinary wear and adjust if necessary.
• Remove drive guards, check tension and lubricate chain every 40 hours
of operation. Adjust tension as required.
• Wipe down the motor casing with a damp cloth making sure to remove all dust that
may have collected since the last maintenance date. Record the cleaning on the
company required documents
TD-09-06-1064 LPV 100 SEED TREATER
ELECTRICAL PANEL
DRIVE AND DRUM
REFER
TO
PAGE 5
REFER
TO
PAGE 5
Page 33