USC LPV100 Operator's Manual page 18

LPV AUTOMATED TREATER SET - UP (BOX-2-BOX TREATERS ONLY)
1. Raise the top assembly with a forklift. Being careful not to hit the LIW gate with the
forks.
2. Remove the bolts (4) from the leg extensions. This will allow the leg extensions to
slide within the tubes on each corner. Each leg extension weigh about 55 lbs. it is
recommended that the leg be supported when the bolt is removed. Use proper
safety precautions.
3. Extend legs so that the distance from the bottom of the leg plate to the bottom of
the metal ring on the bottom of the LIW gate is about 8 feet 2 1/8 inches (98.103
inches). This will put the bolt on the top assembly leg in the top hole on the leg ex-
tension. The hole alignment controls the height.
4. Replace the bolt in each leg and tighten the nut.
5. Place the adjusted unit over the treater such that the center of the discharge tube
on the bottom is centered above the inlet hopper of the treater and adjustable cross
braces are parallel with the long side of the frame of the treater.
6. Adjust the movable cross braces so that the one on the control panel side is above
the door on the treater control panel. This is a code requirement and allows the
control panel to be opened. The one on the other side should be placed just above
the bottom of the top section legs but not contacting the bolts.
7. Connect cables to the treater control panel as outlined on the next page.
8. Release the 4 scale lock levers. See above. These levers must be relocked any
time this stand is moved.
Page 18
TD-09-06-1064 LPV 100 SEED TREATER
Scale Lock
Levers
SET-UP FOR BOX STAND