Exiting Programming - CAME AGTMTMVKIT Installation Manual

Agt v + mtm kit

Hide thumbs

Table Of Contents

Table of Contents

<1''

PROG

a a

b b

Programming the open-gate function

An operator control can be connected to the module auxiliary

relay and/or an operator status to the door status input.

From applicable, preconﬁ gured internal receivers, the relay can

>3''

be controlled using the open-gate command and/or the operator

status shown via the relevant LED on the internal receiver itself.

To conﬁ gure the module with the open-gate function, enable the

function on one of the connected internal receivers, by entering

call programming (see previous paragraph), and send an open-

gate command from the internal receiver (press and hold the

"key" button) as an alternative to or in addition to associating

the call button. The open-gate LED lights up on this internal re-

ceiver to indicate that the function has also been enabled on

the module.

NOTE. If the module is programmed with the open-gate function,

the "door contact input" terminal will function exclusively as an

operator status indicator.

NOTE. This function is available from version 1.03.000 of the

module software.

NOTE. You can force the switch from one programming mode to

another by pressing the PROG button on the module unit for 3

seconds and releasing within 6 seconds. If you force the switch

to call programming from button programming, the button units

which have not been programmed will be conﬁ gured to 8 calls.

If the basic module is not programmed, calls are not conﬁ gured.