Table of Contents
Advertisement
Enabling/disabling
Press the PROG button on the entry panel and hold for at least 20 seconds
The red
and yellow
NOTE: If the intercommunicating function is disabled, follow this procedure to enable it, and vice versa.
The yellow LED
comes on for 2 seconds to show the function has been enabled, or the red LED
the function has been disabled.
NOTE. Program the intercommunicating group after assigning calls to all indoor receivers.
Programming an intercommunicating group
Press and hold the PROG button on the entry panel for at least 8 seconds and release within 11 seconds
The red
and yellow
>20''
>20''
PROG
To enable the intercommunicating function, press the intercommunicating call button you want to call with on the internal receiver you
want to program
. A beep indicates that the function has been programmed successfully. Repeat for all of the other internal receiv-
ers to be included in the intercommunicating group. To conclude programming, press the PROG button on the entry panel briefl y
NOTE. Once an internal receiver has been included in a group by assigning the intercommunicating call button, it cannot be
excluded from this group. If you want to change the call button on an internal receiver which has already been programmed
as an intercommunicating receiver, or you want to add new internal receivers to the group, repeat the operations detailed
under "Programming an intercommunicating group".
PROG
RESTORING FACTORY SETTINGS
To restore the entry panel to the default settings (including the terminal functions
the two call buttons on the unit and power the device.
After 5 seconds the entry panel restarts.
NOTE: if the entry panel does not restart, it has not been restored to factory settings.
LEDs fl ash quickly for 3 seconds
LEDs fl ash to show intercom programming is in progress
.
.
.
,
comes on for 2 seconds to show
.
PROG
>8''
>8''
<11''
<11''
<1''
<1''
PROG
), remove the power supply, press and hold
.
Advertisement
Table of Contents
