Table of Contents
Advertisement
0
100 °
6
82 °
1÷9
4
72 °
54 °
8
Adjusting the brightness level of the light on the entry panel
While programming calls
Press the "auto-connection
panel for which you want to adjust the brightness level. Use a previously assigned call button to increase/
decrease brightness of the light
Reprogramming
When reprogramming a system which has already been programmed, you are taken directly to call programming. To access button
reprogramming, follow the process for forcing the mode switch described above.
If you add, replace or remove an entry panel, you must follow the "programming buttons" procedure so that the system recognises the
changes.
Programming an intercommunicating group
NOTE: Leave the function disabled if the entry panel is connected to a VA/01, A/01 or VSE/301.01.
Before programming an intercommunicating group, enable the intercommunicating function. This function is disabled by default.
Programming the entry panel video camera
While programming the calls, the video camera's fi eld of view can be adjusted from any
receiver. To do this, lift the handset (where present) and press the "auto-connection
button
. From the default confi guration, scroll through the subsequent confi gurations
pressing the AUX1
the AUX2 button
2
7
5
1
9
3
a a , the brightness level of the entry panel light can be adjusted from any receiver.
" button on the internal receiver
.
button or go back to the previous confi gurations by pressing
. Settings are saved automatically.
b b to activate the video camera on the entry
b b
a a
"
Advertisement
Table of Contents
