Table of Contents
Advertisement
3.4 First steps before measuring
After connecting the desired probe, turn on the instrument.
Click
to enter the setup screen (see figure 7).
Figure 7: Setup-Screen
• Select the desired mode - Norm, Memory, A-Scan (Zonotip
explained in chapter 4.1.
• Select the probe which you have connected. A text will appear on the screen. Please
follow these instructions. This process is needed to calibrate the instrument before the first
measurement.
• Please put a little coupling paste onto the built-in zeroing sample (test plate) of the Zonotip
(see figure 2). The thickness of the zeroing sample is 5 mm.
• Select the material you are about to test.
© 2014 Proceq SA
only). The different modes are
+
7
Advertisement
Table of Contents
