Table of Contents
Advertisement
3.2 Connect Probes
The Zonotip is available with two different transducers: The standard 4.0 MHz dual-element trans-
ducer is meant for most measurements (see figure 5). It requires two cables, one for the outgoing
signal, one for the incoming. The optional 2.5 MHz single-element integrated transducer is smaller
and requires only one cable (see figure 6). This makes it more convenient to use in smaller areas
or in areas that are harder to access. The 2.5 MHz is included when purchasing the Zonotip
It is also available separately.
Figure 5: 4.0 MHz transducer (D1771)
3.3 Overview Keypad
6
ON / OFF
Functional Key
Measurement Mode
/ Setup Screen
Enter
Left / Right
Up / Down
Plus / Minus
Figure 6: 2.5 MHz transducer (S3567)
Turn the instrument "on" or "off".
Carry out various actions depending on
the settings. The respective operation is
displayed above each of the keys.
Switch between the measurement modes
and the setup screen.
Confirm a selection.
Navigate through the menu.
Navigate through the menu.
Select and change active parameters.
unit.
+
© 2014 Proceq SA
Advertisement
Table of Contents
