Table of Contents
Advertisement
4.1.3 Memory Mode
The Memory mode of the Zonotip / Zonotip
object, to record the measurement in the memory of the instrument, to browse them on the display
as well as to correct the entries and to conduct re-measurements.
The screen is divided into two parts: the upper part displays information about the measurement,
the lower part shows information about previously saved results.
Up to 500 cells (single measurements) can be stored in up to 100 groups. If the maximum number
of cells in a group is reached, a related information caption will appear on the instrument screen.
To store a measurement, please press
Editing Stored Measurements
1.
Press the
2.
Use the keys to
3.
Press the
4.
By pressing
5.
Press
to exit the edit mode.
Transferring data
Please note that device needs to be in Memory Mode in order to communicate with PC, refer to
section 6. Zonolink
© 2014 Proceq SA
key to enter the edit mode. The screen will show
to select the measurement that needs to be overwritten.
key to start a new measurement.
, the measured data will be stored (the old data will be overwritten).
allows to promptly determine the thickness of the test
+
.
Active bookmark of the Memory
1.
mode
2.
Battery charge indicator
3.
Measurement units
4.
Measurement result
Indicator of the measurement
5.
taking method (see chapter 4.2.1)
Indicator of the signal level
6.
(see chapter 4.2.1)
7.
Number of group
8.
Number of measurement
9.
Stored measurement results
.
11
Advertisement
Table of Contents
