Norm Mode - Proceq Zonotip Operating Instructions Manual

Memory
Clear Memory
A-Scan Scan beginning
Scan end
Gate: beginning
Gate: end
Gain
A-Scan type

4.1.2 Norm Mode

Using the Norm mode is convenient when the measurement results do not have to be recorded.
This mode enables the Zonotip to promptly determine the thickness of the test object and to set
the "monitor" (5) response range. If "monitor" (5) is set to "inside" and the readings are within the
defined limits, the readings are shown in red. If "monitor" is set to "outside" and the readings are
within the defined limits, the readings are shown in white.
10
Run
14
15 Edit
16 Edit
17 Edit
18 Edit
19 Edit
Filled
20
Empty
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
The % amount represents the used
memory capacity
for details see 4.3.2
for details see 4.3.2
for details see 4.3.2
for details see 4.3.2
for details see 4.3.2
Active bookmark of Norm mode
Battery charge indicator
Measurement units
Measurement results
Indicator of the measurement
taking method (see chapter 4.2.1)
Indicator of the signal level (see
chapter 4.2.1)
Current Probe
Lower limit
Upper limit
Current material
US waves velocity in the current
material
© 2014 Proceq SA