emmeti CTTS RF User Manual page 63

The CTTS RF signals the status of depleted batteries switching on the symbol
(10)) and making the display to flash.
In this status the regulation is always guaranteed, but it's advisable to replace the
batteries as soon as possible! (*)
If the charge level of batteries further decreases, the programmable thermostat enters
into less consumption mode, it switches off the display and it doesn't perform any
regulation.
(*) Remove the depleted batteries and replace them with the new ones in a maximum
time of one minute (charge reserve) to avoid to lose the settings of date and time
(the performed programmings on the contrary remain memorized even if this limit is
surpassed).
Attention: after batteries replacement, the display will switch on within 15
seconds at max.
Dispose of the used batteries observing the laws in force
in relation to the disposal of hazardous waste.
EU Conformity declaration
Emmeti declares that the device complies with the Communitary Directive 2014/53 / EU
(RED)
with reference to the following standards:
• ETSI EN 300 220-1 • ETSI EN 300 220-2
• ETSI EN 301 489-1 • ETSI EN 301 489-3
• EN 60730-2-7 • EN 60730-2-9
The full text of the EU Conformity Declaration is available at www.emmeti.com address.
BATTERY REPLACEMENT
REFERENCE STANDARDS
CTTS RF Radiofrequency digital programmable thermostat User Manual
- 29 -
(field