emmeti CTTS RF User Manual page 42

Note: to associate a second remote actuator, activate the configuration of
the actuator channel and, while this last is in configuration mode, remove
the thermostat from the base and re-put it (the cronothermostat starts the
configuration procedure to which follows the testing procedure).
• Indications for placement
The CTTS RF is designed for wall-mounting installation or to cover the 503 box
Fix the base on the wall using the screws
supplied.
Place the programmable thermostat at a height at about 1.5 m above the floor, away
from direct sunlight, away from doors, windows, heat sources, locations with excess or
total lack of aeration.
The actuator is usually placed near the boiler to pilot.
Attention: the maximum distance between CTTS RF and remote actuator is about 50
m in free field. This value is reduced if there are obstacles in the middle (for example,
reinforced concrete walls).
CTTS RF Radiofrequency digital programmable thermostat User Manual
1
1
2
Attach the programmable thermostat to
the base, at first mating teeth first placed
on the upper side.
- 8 -