emmeti CTTS RF User Manual page 41

Keyboard
The keys carry out different functions on the basis of the instrument status and they
will be described step by step in this user manual.
Multipurpose keys are not built into the instrument, that is to say contemporary
pressures of 2 or more keys.
There are two types of pressure:
- brief pressures,
- long pressures, with duration higher than 3 seconds.
During the press of a button, the display is blue.
Attention: press the keys with your fingers, do not use sharp objects!
Attention: the keys are active only if the instrument is hooked to the base
Cleaning the display
To clean the display use a soft, lint-free cloth, without using excess force.
• Association between CTTS RF and remote actuator
Because the CTTS RF and a remote actuator can communicate correctly, it's necessary
to perform a procedure called "self-learning", during which the remote actuator
recognizes and stores the identity of CTTS RF.
To perform the self-learning proceed as follows:
1. Activate the channel configuration of the remote actuator (see the instructions).
The actuator remains in configuration mode for a pre-set time, within which it must
receive the configuration string from CTTS RF.
2. Insert the batteries in the CTTS RF, respecting the polarity indicated on the
instrument (to access the batteries compartment it's necessary to unhook the
thermostat from the base by pressing the tab at the bottom of the instrument).
After about 3 seconds the CTTS RF initiates the configuration procedure (indicated
by on the display) followed by a short test procedure (indicated by
the display) where CTTS RF sends the sequence on-off-on-off to the actuator.
3. Upon receipt of the configuration string, the remote actuator is configured and
resumes the normal operation while the CTTS RF requires date and time insertion (the
programming keys will be active only after you have hooked the thermostat at the base)
INSTALLATION
CTTS RF Radiofrequency digital programmable thermostat User Manual
- 7 -
on