Electrical Nozzle Actuator Wiring - Task Force Tips MONSOON Instructions For Installation, Safe Operation And Maintenance

5.11.2.2 PLATFORM INSTALLATION ELECTRICAL WIRING (-P MODELS)
The electronics enclosure converts discrete input signals into serial communications for controlling the monitor. The discrete input
signals can be from a joystick, toggle switches, relay contacts or Canbus output module. The electronic interface accepts +12/24 volt
signals, but can be field changed to accept ground signals. See section 5.7.3.
The electronics enclosure is configured so that signals connected to the PRIMARY CONTROL cable will override any other operator
stations (see section 6.2.1).
See Figure 5.11.2.2 for wiring connections.
NOTE: To avoid excessive voltage drop at monitor operator station, cable
selection is critical.
Voltage supplied to ELECTRICS ENCLOSURE should not fall below 11
volts when monitor is in operation.
Toggle Switch
Operator Station (Y4E-TS)
Sec 5.6
5.12 ELECTRIC NOZZLE ACTUATOR WIRING
The electric Monsoon RC monitor is designed to control and is factory wired for an electric actuated nozzle. A Task Force Tips, Inc.
Masterstream 1250, 1500 or 2000 nozzle is available with the proper electric connection. After mounting the Masterstream 1250, 1500
or 2000 nozzle onto the monitor, plug the male cord from the nozzle into the female cord located on the outlet of the monitor. Make sure
the two coupling nuts are tightened securely to ensure a proper watertight seal.
If retrofitting an existing TFT nozzle, a male cord (TFT #Y5285) can be purchased and installed in place of the existing actuator cord.
Please consult factory for installation.
©Copyright Task Force Tips, Inc. 2004-2005
Recommend Cable Gauge
Max Length
40 ft . . . . . . 14AWG
65 ft . . . . . . 12AWG
80 ft . . . . . . 2-14AWG
105 ft . . . . . . 10AWG
130 ft . . . . . 2-12AWG
-or-
Figure 5.11.2.2
Electrical Components
(platform installations)
Gauge
25
LIY-200 September 14, 2005 Rev02