Output Channel Control Switches - ETC ArcLamp System Installation Manual

Output Channel Control Switches

Each output channel on the ArcLamp Driver is controlled by a switch block (S1–S4, shown
below). Switch positions 2–5 are factory set to allow individual control of each output. In order
to bridge channels together, you must adjust the positions of switches 2–5.
S4
S3
Switch
blocks
S2
S1
ArcLamp Driver 150
Switch Blocks
Each of the four switch blocks controls one output channel.
Switch block S1 controls the output channel labeled "LED OUT 1" on ArcLamp Driver 150
•
or "CH 4" on ArcLamp Driver 350 and 700.
Switch block S2 controls the output channel labeled "LED OUT 2" on ArcLamp Driver 150
•
or "CH 3" on ArcLamp Driver 350 and 700.
Switch block S3 controls the output channel labeled "LED OUT 3" on ArcLamp Driver 150
•
or "CH 2" on ArcLamp Driver 350 and 700.
Switch block S4 controls the output channel labeled "LED OUT 4" on ArcLamp Driver
•
150 or "CH 1" on ArcLamp Driver 350 and 700.
40
LED OUT 4
LED OUT 3
S1
S2
LED OUT 2 Switch
blocks
S3
LED OUT 1
S4
Wall-Mount ArcLamp Driver 350/
Wall-Mount ArcLamp Driver 700
CH 1 CH 2 CH 3 CH 4
Rack-Mount ArcLamp Driver 350/
Rack-Mount ArcLamp Driver 700
CH 4
CH 3
CH 2
CH 1
Switch
blocks
S4 S3 S2 S1
ArcLamp System Installation Manual