Installation Location; Arclamp Drivers; Power Disconnect Device - ETC ArcLamp System Installation Manual

Installation Location

ArcLamp System is designed for use in 0–40°C (32–104°F) ambient temperature.

ArcLamp Drivers

Note:
conduit hardware, and all cable required for installation.
ArcLamp Rack-Mount Driver
Rack-mounted ArcLamp drivers require a 19-inch equipment rack. Each ArcLamp driver requires
one unit (1U) of rack space.
Note:
personnel and service persons can gain access with the use of a key. If this equipment is
installed in a location without restricted access, the wiring area of the rack should only
be accessible with the use of a tool.
ArcLamp Wall-Mount Driver
Wall-mounted ArcLamp drivers require 7.6 cm (3 in) clearance around the side vents for proper
ventilation.

Power Disconnect Device

Before installation, make sure you have a main circuit breaker cabinet or other readily
accessible input power disconnect device installed ahead of your ArcLamp driver.
WARNING:
power to the system before installation, maintenance, cleaning, or any
other system modification could result in serious injury or death.
AVERTISSEMENT :
Négliger de débrancher toutes les sources d'alimentation du système avant
l'installation, l'entretien, le nettoyage ou toute autre modification du
système peut causer des blessures graves ou la mort.
De-energize main feed to ArcLamp drivers and follow appropriate
Lockout/Tagout procedures as mandated by NFPA 70E. It is important to
note that this electrical equipment can present an arc flash hazard if
improperly serviced. This is due to the high amounts of short-circuit current
available on the electrical supply to this equipment. Any work must comply
with OSHA Safe Working Practices.
WARNING:
disconnect device cannot be serviced or operated safely.
AVERTISSEMENT :
installés sans qu'un dispositif de déconnexion de l'alimentation ne soit
accessible.
12
Mounting hardware and installation location must support the ArcLamp driver,
Install this device in a location with restricted access where only qualified
RISK OF DEATH BY ELECTRIC SHOCK! Failure to disconnect all
RISQUE DE MORT PAR DÉCHARGE ÉLECTRIQUE!
Circuits that are installed without an accessible power
Il est imprudent d'utiliser ou de réparer les circuits
ArcLamp System Installation Manual