Ground The Equipment - Graco SaniForce 24V310 Instructions - Parts Manual

5:1 and and 6:1 6:1 Models: Models: Use screws (406) to attach
4. 5:1 5:1 and 6:1 Models:
the tie rod guard (407) to the mounting bracket
(401). Cut trim (410) to fit and place on the sharp
edges of the guard. Do
pump without without the the guard guard in in in place.
pump pump without the guard
Mobile Models: Models: Attach the drive handle (501) to
5. Mobile Mobile Models:
the air control mounting plate. Use screws (502),
washers (503), and nuts (504). Hand tighten.
333406D
Do not Do not operate not operate the operate the 5:1 the 5:1 or or or 6:1 5:1
place.
place.
Ground the the Equipment
Ground Ground the
6:1 6:1
The equipment used with the elevator must be
grounded to reduce the risk of static sparking.
Static sparking can cause fumes to ignite or
explode. Grounding provides an escape wire for
the electrical current.
Pump: Pump: Pump: Connect a ground wire (Graco PN 238909) to
the ground screw on the air motor base. Connect the
other end of the ground wire to a true earth ground.
Air and and fluid fluid hoses: hoses: Use only electrically conductive
Air Air and fluid hoses:
hoses with a maximum of 500 ft. (150 m) combined
hose length to ensure grounding continuity. Check
electrical resistance of hoses. If total resistance
to ground exceeds 25 megohms, replace hose
immediately.
Air compressors: compressors: Follow manufacturer's
Air Air compressors:
recommendations.
Dispense valve: Dispense Dispense valve: valve: Ground through connection to a
properly grounded fluid hose and pump.
Material Material Material supply supply supply container:
Container(s) Container(s) that Container(s) that that receive
Solvent pails pails used used when
Solvent Solvent pails used
code. Use only conductive metal pails, placed on
a grounded surface. Do not place the pail on a
nonconductive surface, such as paper or cardboard,
which interrupts grounding continuity.
To maintain To To maintain grounding maintain grounding continuity grounding
relieving pressure: pressure: Hold metal part of the dispense
relieving relieving pressure:
valve firmly to the side of a grounded metal pail, then
trigger the valve.
Equipment
Equipment
container: Follow local code. container:
receive material: receive material: Follow local code. material:
when flushing: flushing: Follow local
when flushing:
continuity when continuity when flushing when
Installation
flushing or or or flushing
11