Start And Adjust The Equipment; Shut Down The Equipment - Graco SaniForce BV Series Instructions Manual

Start and Adjust the Equipment

1. Confirm that the equipment is properly grounded.
See Grounding, page 7.
2. Check and tighten all fasteners, air connections,
and fluid connections before operating the
equipment. Replace worn or damaged parts as
needed.
NOTICE
Firmly tighten all fasteners and connections to avoid
air or fluid leaks. To avoid equipment damage, do
not over-torque the fasteners on the equipment. See
Torque Fasteners, page 36 .
3. Connect a flexible, conductive fluid supply line (G)
from the fluid to be pumped to the fluid inlet
port (R).
4. Connect the flexible, conductive fluid outlet line (L)
to the fluid outlet port (S) and route the line to the
end container.
5. Close the fluid drain valve (J).
6. Turn the air regulator (C) to the lowest air pressure
setting and open the bleed-type master air
valve (B).
3A8983A
7. If the fluid outlet line (L) has a dispensing device,
hold it open while continuing with the following
step.
8. To prime the pump, slowly increase air pressure
with the air regulator (C) until pump starts to cycle.
Do not exceed the maximum operating air pressure
listed in the Technical Specifications, page 45.
Allow the pump to cycle slowly until all air is pushed
out of the fluid lines and fluid exits the fluid outlet
line (L).

Shut Down the Equipment

1. Follow Pressure Relief Procedure, page 12.
2. Follow Flush the Equipment, page 15.
Operation
13