Graco 225773 Instructions Manual
  1. Manuals
  2. Brands
  3. Graco Manuals
  4. Water Pump
  5. 225773
  6. Instructions manual
Graco 225773 Instructions Manual

Graco 225773 Instructions Manual

50:1 ratio fire-ball lubrication pump
Hide thumbs Also See for 225773:
Table of Contents

Advertisement

Quick Links

Instructions
50:1 Ratio Fire-Ball
Lubrication Pump
Portable units for heavy grease. For professional use only.
See page 2 for model information, including maximum
working pressure and approvals.
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
These systems are designed to be used only in
pumping non-corrosive and non-abrasive lubricants
and grease. Any other use of the system can cause
unsafe operating conditions and result in component
rupture, fire, or explosion which can cause serious
injury, including fluid injection.
®
Model 240883 shown
307878Y
EN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 225773 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Graco 225773

Summary of Contents for Graco 225773

  • Page 1 Instructions ® 50:1 Ratio Fire-Ball Lubrication Pump 307878Y Portable units for heavy grease. For professional use only. See page 2 for model information, including maximum working pressure and approvals. Important Safety Instructions Read all warnings and instructions in this manual. Save these instructions. These systems are designed to be used only in pumping non-corrosive and non-abrasive lubricants and grease.

  • Page 2: Table Of Contents

    Technical Data ......17 Graco Standard Warranty ....18...

  • Page 3: Warnings

    Warnings Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama- tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.
  • Page 4 Warnings WARNING SKIN INJECTION HAZARD High-pressure fluid from dispensing device, hose leaks, or ruptured components will pierce skin. This may look like just a cut, but it is a serious injury that can result in amputation. Get immediate surgical treatment. •...

  • Page 5: Installation

    . 2 for the following instructions. The equipment must be grounded to reduce the risk 1. Models 225773, 240883, and 245695 only : of static sparking and electric shock. Electric or static Assemble the truck as shown in the parts drawing sparking can cause fumes to ignite or explode.

  • Page 6: Models 225006, 225026, 240880, 240881, And

    Installation Models 225006, 225026, 240880, 240881, and 245696 2c, 2d Refer to F . 3 for the following instructions. 1. Models 225006 and 240880 : Assembly the base (3) as shown in the Parts Drawing on page 14. Models 225026, 240881, and 245696 : Assemble the truck (3) as shown in the Parts Drawing on page 2.

  • Page 7: Models 222069, 240885, And 245694

    Installation Models 222069, 240885, and Models 222245 and 240882 245694 Refer to F . 5 for the following instructions. Refer to F . 4 for the following instructions. 1. Assemble the cart (6). Use only 2 of the 4 brackets (5d) supplied.

  • Page 8: Models 226012 And 240886

    Installation Models 226012 and 240886 11. Center the inductor plate (5) in the pail opening. Press down on the pump and rock it back and forth to seat the inductor plate to eliminate air pockets. Refer to F . 7 for the following instructions unless other Continue action until material appears at the vent wise indicated.

  • Page 9: Typical Installation

    Installation Typical Installation The installation shown below is only a guide for selecting and installing system components and accessories. Con- tact your Graco distributor for assistance in designing a system to suit your particular needs. Key: Fluid dispense line Pump ground wire (required)

  • Page 10: Air Line And Accessories

    Installation Air Line and Accessories NOTE: Install air line accessories in the order shown in • Install the air regulator (C) to control pump speed the Typical Installation. and pressure. • Install a pump runaway valve (G) to shut off the air •...
  • Page 11 Installation 6. Set the air pressure to each pump at the lowest pressure needed to get the desired results. NOTE: A pump runaway valve can be installed not he air line to automatically shut off the pump if it starts to run too slow.

  • Page 12: Parts

    Parts Parts Ref No 2, Dispense Kit 222070 Ref. Part No. Description 109151 HOSE, 1/4 npt (mbe), 12 ft (3.7 m) 242056 VALVE 114558 COUPLER, quick-disconnect 169971 NIPPLE, quick-disconnect 202577 Z-SWIVEL Ref No. 2 Model 225827, 240884: 35 lb to 50 lb pail size Ref.
  • Page 13 306345 for parts, model 255026 203976 HOLSTER 240831 CE INSTALLATION KIT, See parts on page 16, model 240881 Model 225773, 245695, 2480883: 35 lb to 50 lb pail size Ref. Part No. Description 239877 PUMP, 50:1 Fire-Ball, See manual 308883 for parts...
  • Page 14 Parts Model 225006, 240880: 120 lb drum size Ref. Part No. Description Qty. 239887 PUMP, 50:1 Fire-Ball, See manual 308883 for parts 222070 DISPENSE KIT, See parts, page 12 203622 PORTABLE BASE, See parts list below 204574 COVER, See manual 306345 for parts, model 240880 24R350 COVER, See manual 306345 for parts, model 225006...
  • Page 15 Parts Ref No. 2, Dispense Kit 222838 Part No. Description 109154 HOSE 242056 VALVE 114558 COUPLER, quick-disconnect 169971 NIPPLE, quick-disconnect 202577 Z-SWIVEL Ref No. 2 Model 222245, 240882: 120 lb drum size Part No. Description 239887 PUMP, 50:1 Fire-Ball, See manual 308883 for parts 222383 DISPENSE KIT, See parts list above...
  • Page 16 Parts Model 226012, 240886: 50 lb pail size Ref. Part No. Description Qty. 239877 PUMP, 50:1 Fire-Ball, See manual 308883 for parts 222070 DISPENSE KIT, See parts, page 203650 TRUCK, portable, See parts list on page 13 203664 ELEVATOR 204351 FOLLOW PLATE 203976 HOLSTER 240831 CE INSTALLATION KIT, See parts list below, model 240886...

  • Page 17: Technical Data

    Technical Data Technical Data 50:1 Ratio Fire-Ball Lubrication Pumps Metric Maximum fluid working pressure 5000 psi 35 MPa, 350 bar Maximum Air Inlet Pressure 100 psi 0.7 MPa, 7 bar Sound (dBa) Tested at 100 psi (0.7 MPa, 7 bar) at 40 cycles per minute Sound Pressure Level, measured at 1 77.9 dB(A) meter from unit...

  • Page 18: Graco Standard Warranty

    With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.

This manual is also suitable for:

225827240884240883225006225026240880 ... Show all

Table of Contents