Install The Fill Cap; Flush Before Using The Equipment - Graco E-Flo DCi Instructions Manual

Installation
Torque to 7 in-lb (0.79 N•m)
1
Torque to 15 ft-lb (20 N•m)
2
A conduit seal is required
within 457 mm (18 in.) of the
3
motor for US and Canadian
installations.
EC CS
CS
2
2
3/4 14 npt(f)
TS CS
1 2
CS
2
F . 5 Motor electrical compartment wires
IG
10

Install the Fill Cap

The motor is pre-filled with oil. Replace the shipping
plug with the fill cap (FC) before first use.
A
3
F
Flush Before Using the
Equipment
The pump fluid section was tested with lightweight oil,
which is left in the fluid passages to protect parts.To
avoid contaminating your fluid with oil, flush the
equipment with a compatible solvent before using the
equipment.
. 6 Fill cap
IG
FC
3A7828B