Start And Adjust The Pump; Change Drums - Graco SaniForce 24V310 Instructions - Parts Manual

Operation
Start and and Adjust Adjust the
Start Start and Adjust
1. Set the pump air switch to ON.
increase pump air regulator pressure until
desired flow is achieved.
NOTE: The pump regulator is set at the factory NOTE: NOTE:
to relieve pressure at 80 psi, the maximum inlet
pressure of the SaniForce 5:1 pump. SaniForce
2:1 and 6:1 pumps can use up to 100 psi. If more
supply pressure is needed for a 2:1 or 6:1 pump,
adjust the relief valve (209) on the back of the
pump regulator to relieve at higher pressures.
NOTICE
NOTICE NOTICE
To avoid equipment damage, do not exceed
the maximum pressure rating of your pump.
16
the Pump Pump
the Pump
Slowly
2. Turn the pump air switch to OFF
the drum is empty, or any time the pump begins
to run too fast.
NOTICE
NOTICE NOTICE
To avoid equipment damage, do not let the
pump runaway.

Change Drums

Change Change Drums Drums
1. Set the pump air switch to OFF.
2. Open the fluid ball valve and/or dispensing valve
to relieve fluid pressure.
Mobile Models: Models: Unlock the cart wheels.
3. Mobile Mobile Models:
4. Set the elevator director switch to UP
the pump out of the drum.
Stationary Models: Models: Remove the empty drum and
5. Stationary Stationary Models:
place the full drum against the elevator base.
Mobile Models: Models: With air connected and the
Mobile Mobile Models:
main air valve in the open position, the cart can
be moved short distances while the elevator is
raised. If you are going to turn off or disconnect
the air to move the cart, lower the elevator all the
way. Move the cart into position by a full drum.
6. With your hands away from the drum, set the
elevator director switch to DOWN.
Fully lower the pump into the drum. Mobile
Models: Lock the cart wheels.
Models: Models:
when
to lift
Mobile Mobile
333406D