Service The Pump; Lubricate The Packing; Remove Water From Air Cylinder; Repair Or Replace Air Control Parts - Graco SaniForce 24V310 Instructions - Parts Manual

Repair
Service the the Pump Pump
Service Service the Pump
1. Follow the Pressure Relief Procedure, page
2. Follow all directions and warnings in your pump
manual to repair or service the pump.
Lubricate the the Packing Packing
Lubricate Lubricate the Packing
As needed, remove the packing (109) and apply
appropriate waterproof sanitary lubricant to the
external surface. Replace the cap and torque to 20
to 40 ft-lb (37–54 N•m).
20
Remove Water Water from
Remove Remove Water
Occasionally water may accumulate in the cylinder
from condensation.
1. Follow the
2. Remove the plug (134).
14.
3. Allow all water to drain.
4. Apply thread sealant or PTFE tape to the plug
and reinstall.
Repair or or or Replace Replace Air
Repair Repair Replace
If you remove any parts in the Air Controls (127), see
Appendix A for information on properly reconnecting
any affected air lines.
from Air Air Cylinder Cylinder
from Air Cylinder
Pressure Relief Procedure, page
Air Control Control Parts
Air Control
14.
Parts
Parts
333406D