Clean the
the Elevator
Elevator and
Clean
Clean
the
Elevator
NOTE: The following instructions are a basic
NOTE:
NOTE:
procedure for cleaning a sanitary elevator.
Be sure
sure to follow your national and state sanitary
• Be
Be
sure
standard codes and local regulations.
• Use appropriate cleaning and disinfecting agents,
at intervals appropriate for product processed.
• Follow cleaning product manufacturer's
instructions.
1. Use the elevator to remove the pump from the
fluid container and place it in an empty drum.
Operate the pump to remove as much fluid as
possible.
2. Flush the system thoroughly with an appropriate
cleaning solution.
333406D
and Pump
Pump
and
Pump
3. Remove the pump.
a. Disconnect the fluid hose.
b. Use the elevator to remove the pump from
the drum.
c. Stationary
Stationary models:
Stationary
models: Remove the drum.
models:
Mobile models:
Mobile
Mobile
models:
models: Move the elevator to cleaning
location. Lower the elevator so the pump
rests on a clean, slightly raised surface.
d. Remove the clamp
e. Raise the elevator. The motor, tie rods, and
displacement rod will separate from the rest
of the pump.
f.
Remove all pump parts for cleaning, then
lower the elevator again.
Note:
Note: The pump must
Note:
to clean it thoroughly. See your separate
pump manual for complete flushing and
cleaning procedures for a sanitary pump.
Any damaged rubber parts must be replaced
as they could harbor microorganisms that
can contaminate the fluid.
4. Clean external surfaces of the elevator and air
motor before reassembly.
Shutdown
Shutdown
Shutdown
1. Follow the
Pressure Relief Procedure, page
2. Follow the pump shutdown instructions in your
separate pump manual.
Operation
must be
must
be disassembled
be
disassembled
disassembled
14.
17