Graco SaniForce 24V310 Instructions - Parts Manual page 6

Warnings
EQUIPMENT MISUSE EQUIPMENT EQUIPMENT
Misuse can cause death or serious injury.
• Do not operate the unit when fatigued or under the influence of drugs or alcohol.
• Do not exceed the maximum working pressure or temperature rating of the lowest rated
system component. See Technical
• Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data
in all equipment manuals. Read fluid and solvent manufacturer's warnings. For complete
information about your material, request MSDS from distributor or retailer.
• Do not leave the work area while equipment is energized or under pressure. (If applicable.)
• Turn off all equipment and follow the Pressure
• Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
manufacturer's replacement parts only.
• Do not alter or modify equipment. Alterations or modifications may void agency approvals
and create safety hazards.
• Make sure all equipment is rated and approved for the environment in which you are using it.
• Use equipment only for its intended purpose. Call your distributor for information.
• Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
• Do not kink or over bend hoses or use hoses to pull equipment.
• Keep children and animals away from work area.
• Comply with all applicable safety regulations.
PLASTIC PARTS
PLASTIC PLASTIC
Many solvents can degrade plastic parts and cause them to fail, which could cause serious
injury or property damage.
• Use only compatible water-based solvents to clean plastic structural or pressure-containing
parts.
Technical Data
• See Technical Technical
solvent manufacturer's MSDSs and recommendations.
MOVING PARTS
MOVING MOVING
Moving parts can pinch, cut or amputate fingers and other body parts.
• Keep clear of moving parts.
• Do not operate equipment with protective guards or covers removed.
• Pressurized equipment can start without warning. Before checking, moving, or servicing
equipment, follow the Pressure
6
WARNING WARNING WARNING
MISUSE HAZARD MISUSE HAZARD HAZARD
Technical Data Technical
PARTS CLEANING CLEANING SOLVENT SOLVENT HAZARD
PARTS CLEANING SOLVENT
Data in this and all other equipment instruction manuals. Read fluid and
Data
PARTS HAZARD HAZARD
PARTS HAZARD
Pressure Relief
Pressure
Data in all equipment manuals. Data
Pressure Relief Pressure Relief Procedure Relief Procedure when equipment is not in use. Procedure
HAZARD
HAZARD
Relief Procedure Procedure and disconnect all power sources.
Relief Procedure
333406D