Agilent Technologies 7000 Series Operating Manual page 98

5 Operating in EI Mode
To change the network settings of the TQ
3 Click Edit NetConfig, and go to Edit NetConfig (QQQ network configuration).
Figure 27.
4 Enter the GC IP Address in the DCOMM Partner IP Address if your GC
5 Enter the IP Address, Gateway IPA, and Subnet Mask for the TQ.
6 Click Submit to assign this IP address to the TQ.
7 Close the browser page when you are done.
8 Run the Agilent GC/MS Instrument Configuration program. To configure the
98
(See Figure 27.)
WUI Edit NetConfig
supports DCOMM. Your GC must be an Agilent 7890B or 7890A+ with the
latest firmware for DCOMM support.

Agilent recommends attaching a label to the TQ recording these NetConfig
parameters.
TQ for DCOMM you must first configure the GC before configuring the TQ in
7000/7010 Series TQ GC/MS Operating Manual