Agilent Technologies 7000 Series Operating Manual page 64

3 Installing Intuvo 9000 GC Column
To Replace the 9000 GC/MS Tail
Ferrule release hole
Transfer line
Bus click and run
connection
Figure 14.
Exit in ion
source
Figure 15.
13 Replace the gasket. (See
14 Carefully slide the 9000 GC/MS Tail into the GC/MS interface, and gently
15 Check that the 9000 GC/MS Tail click and run fitting sits flat against the
16 Screw the 9000 GC/MS Tail column nut to the transfer line threaded
17 Loosely install the two compression bolts.
Use the Intuvo torque driver to tighten the compression bolt until you hear one
C AU T I O N
click. Over-tightening can damage the flow path, strip the fittings, and cause
leaks.
64
MS tail heater assembly clamp open with 9000 GC/MS Tail removed
9000 GC/MS Tail removed from GC/MS Interface
page 57.)
place the click and run connection into the bus connection.
gasket in the bus connection.
connector finger tight, then use a ¼-inch wrench to tighten the nut an
additional 20 to 30 degrees.
Ferrule and nut
Click and run connection
"To Replace an Intuvo 9000 GC Gasket"
7000/7010 Series TQ GC/MS Operating Manual
on