Agilent Technologies 7000 Series Operating Manual page 108

5 Operating in EI Mode
To Set Monitors for MS Temperature and Vacuum Status
2 In the Available Monitors column, select MS High Vac and click Add to move
3 In the Available Monitors column, select MS 1 Heater, and click Add to move
4 In the Available Monitors column, select MS 2 Heater, and click Add to move
5 In the Available Monitors column, select MS Turbo Speed, and click Add to
6 In the Available Monitors column, select MS Source Temp, and click Add to
7 In the Available Monitors column, select Foreline Pressure, and click Add to
8 Select any other monitors you want, and add them to the Selected Monitors
9 Click OK. The new monitors will be stacked on top of each other in the lower
10 Select Window > Arrange Plots and Monitors, or click and drag each monitor
Figure 31. Arranging monitors
11 To make the new settings part of the method, select Save from the Method
108
the selection to the Selected Monitors column.
the selection to the Selected Monitors column.
the selection to the Selected Monitors column.
move the selection to the Selected Monitors column.
move the selection to the Selected Monitors column.
move the selection to the Selected Monitors column.
column.
right corner of the Instrument Control window.
to the desired position. See
menu.
Figure 31 for one way of arranging the monitors.
7000/7010 Series TQ GC/MS Operating Manual