Table of Contents
Advertisement
1
Finishing the Installation
After finishing insulating and taping over the tubing, use sealing
putty to seal off the hole in the wall to prevent rain and draft
from entering.
Apply putty here
HOW TO INSTALL THE TIMER REMOTE
CONTROLLER OR HIGH-SPEC WIRED
REMOTE CONTROLLER (OPTIONAL PART)
NOT E
See "Section 2. TEST RUN".
Accessories Supplied with Unit
(4-Way Cassette)
Part Name
Full-scale
installation
diagram
Washer
Screw
Insulating tape
Flare insulator
Flare insulator
Drain hose
Hose band
Tubing
Figure
Q'ty
Remarks
Printed on
1
container box
For suspension
8
bolts
For full-scale
4
installation diagram
For gas and liquid
2
tube flare nuts
1
For liquid tube
1
For gas tube
1
For securing drain
1
hose
Part Name
Packing
Drain insulator
Clamper
Operating
Instructions
Installation
Instructions
Use M10 for suspension bolts.
Field supply for suspension bolts and nuts.
Type of Copper Tube and Insulation Material
If you wish to purchase these materials separately from a local
source, you will need:
1.
Deoxidized annealed copper tube for refrigerant tubing.
2.
Foamed polyethylene insulation for copper tubes as
required to precise length of tubing. Wall thickness of the
insulation should be not less than 8 mm.
3.
Use insulated copper wire for field wiring. Wire size varies
with the total length of wiring. See the section
"1-11. ELECTRICAL WIRING" for details.
CAUTION
Check local electrical codes and regulations before
obtaining wire. Also, check any specified instructions or
limitations.
Additional Materials Required for Installation
1.
Refrigeration (armored) tape
2.
Insulated staples or clamps for connecting wire (See your
local codes.)
3.
Putty
4.
Refrigeration tubing lubricant
5.
Clamps or saddles to secure refrigerant tubing
6.
Scale for weighing
1-12-2-2-9
Figure
Q'ty
Remarks
1
1
4
For electrical wiring
1
1
Hide quick links:
Advertisement
Chapters
Table of Contents
