Wiring For The Receiver; Common To All Models - Panasonic Elite Big PAC-i S-200PE3E5B Technical Data & Service Manual

Wiring for the Receiver

8-32. Common to All Models

1. Installation Location for the Receiver
The wireless remote controllers use a very weak infrared light for its signal, which can result in the signal not being received
because of the following influences, so take care in where the unit is installed.
• Inverter or rapid-start type fluorescent lights. (Models without glow lamps)
• Plasma display or LCD televisions.
• Direct sunlight or other sources of bright light.
Do not bundle together with the power source wiring or store in the same metal tube. Operation error may occur.
Be careful not to connect cables to other terminals of indoor units (e.g. power source wiring terminal). Malfunction may occur.
Avoid the following locations for installation.
• Location where condensation occurs
• Location where voltage fluctuation frequently occurs
• Location where there is a machine producing electromagnetic radiation
2. Installation location for the Wireless Remote Controller
If a remote controller is to be operated from a remote control holder that is hung on a wall, turn on the lights in the room as
well as any electrical appliances and then check to make sure the air conditioner works with the remote controller in the
location where it will be installed. If it works, continue with installation.
If the main sensor is to be switched from the indoor unit to a remote controller, pay attention to the following when installing.
• Locate where no warm or cold air will affect it.
• Locate in a place free from direct sunlight.
• Locate where it will not be affected by any other heat/cold source.
.
8-27
8