Panasonic Elite Big PAC-i S-200PE3E5B Technical Data & Service Manual page 286

Checking Addresses
RC
1. Press with one end of an unfolded paper clip
ADR
(or a similar object that can fit).
• Its current address appears on the display for 5 seconds.
• If this address corresponds to the address of a receiver, the buzzer
sounds. (If it is on ALL, the buzzer will always sound.)
• If it is on ALL, it can be operated regardless of receiver addresses.
Point the remote controller at the receiver you wish to operate and
transmit.
Matching Up Addresses
■
If not wall mounted type indoor unit
< Setting Remote Controller Addresses >
RC
1. Press with one end of an unfolded paper clip
ADR
(or a similar object that can fit) for 4 seconds or longer.
• The current address number starts blinking.
RC
2. Press to select the address of the receiver you want to
ADR
control, and press
• Every time you press
1 → 2 → 3 → 4 → 5 → 6".
• If it corresponds to the receiver's address setting, the buzzer sounds.
Note
• Set the address of the receiver as instructed in the operating instructions of your
receiver. Do not set by yourself. Contact the dealer where the product was
purchased.
■
For wall mounted type indoor unit
< Setting the address of the indoor unit >
1. Press [Emergency Operation]
• OPERATION lamp, TIMER lamp, and then STANDBY lamp repeatedly light one after the other for 1 second
each to indicate the unit is ready for address setting.
< Setting Remote Controller Addresses >
2. Set the address for the remote controller following the procedure under the section
" ■ If not wall mounted type indoor unit" (see this section noted above).
• Repeat Step 2 under " ■ If not wall mounted type indoor unit" if you are setting more units.
• The address setting ready status of the indoor unit ends if data transmission is not received from the remote
8
controller for 3 minutes.
• Press [Emergency Operation]
.
RC
, it cycles from "ALL (All the addresses) →
ADR
of the indoor unit for 4 seconds or longer.
on the receiver to end the address setting ready status of the indoor unit.
1
8-10
Address
Address
2
1, 2