Panasonic Elite Big PAC-i S-200PE3E5B Technical Data & Service Manual page 55

Examples of shield wires
(1) Remove cable coat not to scratch braided shield.
(2) Unbraid the braided shield carefully and twist the
unbraided shield wires tightly together. Insulate the shield
wires by covering them with an insulation tube or wrapping
insulation tape around them.
Wiring samples
<Type E3>
<Type U2>
Clamping
1
Clamper * Clip
(supplied)
*1 Fasten tightly.
Insulation tape Shield mesh
Earth wiring:
Make the earth wiring 25 - 30 mm longer
than power cable.
Power
supply
Remote Control
Wiring
Inter-unit Control
Wiring
(3) Remove coat of signal wire.
(4) Attach ring pressure terminals to the signal wires and
the shield wires insulated in Step (2).
Earth wire for power supply
The earth wire should be longer than the
other lead wires for electrical safety.
Power cable
Inter-unit control Remote control
wiring wiring
Power cable
Earth Wiring:
Make the earth wiring 25 - 30 mm longer than power
cable.
Power Supply
Use this screw when connecting the shield
for the Inter-unit control wiring to ground.
( : Functional earthing)
1-11-5
Insulation tape Shield mesh
Ground terminal fixing for
( : Functional earthing)
Clamper (supplied)
1
Clamper *
(supplied)
1