Panasonic Elite Big PAC-i S-200PE3E5B Technical Data & Service Manual page 132

1
ECONAVI SYSTEM SETTING
Change the settings of main and sub indoor units to
correspond to the ECONAVI system function.
For the benefit of using the ECONAVI function, the main
indoor unit should be provided with the ECONAVI function.
1. Press three buttons.
Keep pressing the
simultaneously for more than 4 seconds.
The "Maintenance func" menu appears on the screen.
2. Select "0. ECONAVI info." from the menu command.
By pressing the
"0. ECONAVI info." and press the
3. Select "System settings" from the menu command.
By pressing the
"System settings" and press the
NOT E
After operating Step 2, the following messages may occasionally appear on the screen.
Display message
Disabled in default mode.
After operating Step 3, the following messages may occasionally appear on the screen.
Display message
Setup is not required.
Main indoor unit is not found.
Indoor unit with ECONAVI is not found.
, and buttons
/ buttons, select
button.
/ buttons, select
button.
After a while, select "0. ECONAVI info." again.
If no status changes even after 10 minutes, make auto address setting and then
select "0. ECONAVI info.".
The main indoor unit has already been provided with the ECONAVI function.
So, it works right out of the box.
The power of indoor unit may possibly shut down.
Check the power supply of indoor unit.
Since all indoor units in the group control are not available for the ECONAVI
function, the ECONAVI function cannot be used.
4. Start settings.
By pressing the
press the
5. When finished settings, the system restarts automatically.
6. Check whether the ECONAVI function is set.
If the display is not operated, press the
and set it in operating mode.
If operation is in fan mode,
displayed. Set in any operating mode other than fan
mode.
"
setting the ECONAVI function.
Contents
Contents
1-12-2-2-25
/ buttons, select "YES" and
button.
is displayed on the screen.
is not
" is displayed when
button