Timer Operation - Panasonic Elite Big PAC-i S-200PE3E5B Technical Data & Service Manual

8-5. Timer Operation

• When setting the timer, make sure the current time on the remote controller is accurate.
• The timer's clock can only be set when the display of the remote controller is ON.
• After setting the timer, put the remote controller for in a place where its signal will reach the receiver of the indoor unit.
1. Press or twice.
• The time last set on the timer starts blinking. ("
when the timer is not set or after replacing batteries.)
2. Press / to set the timer to the desired time.
• Every time you press
increments.
• If you press and hold the button, the time changes quickly.
3. Press .
• The timer display stops blinking and the display reverts to
the current time after 3 seconds.
• " / " is displayed when set.
Combining ON and OFF Timers
1. The ON and OFF timers can be set respectively.
Checking the timer setting
1. Press or .
• The scheduled time is displayed for 4 seconds.
• When the timer is not set or after replacing batteries, it displays "
Changing a timer setting
1. Perform Step 1 to 3 noted above as you did when setting.
Canceling a timer setting
1. Press .
• If you wish to cancel the setting for either the
displayed.
Using the same timer setting every day
1. Press for 2 seconds or longer.
• " " is displayed when set.
• If you press again for 2 seconds or longer, "
/ , the time changes in 10 minute
or the
8-7
" blinks
1
2
". (Initial setting)
timer, press
" goes off and the timer operates only once.
3
while the scheduled time is
8