Installation; Required Materials - National Instruments UMI-7774 User Manual

Installation

Required Materials

The same power supply may be used for both the main +24 V power supply and I/O.
Note
However, if you use the same power supply for both connections, there will be no isolation
between the I/O and the main power.
Note For a current list of the third-party drives that the UMI-7774/7772 supports, visit the
National Instruments Motion Control Web site at
© National Instruments Corporation
This chapter describes the necessary and optional items for getting started
with the UMI-7774/7772. This chapter also explains how to unpack,
configure, and install the UMI-7774/7772.
The following items are necessary for installing and getting started with
the UMI-7774/7772:
❑
UMI-7774 or UMI-7772
❑
24 ±10% VDC power supply (10 W minimum)
❑
5 to 30 V isolated power supply (10 to 60 W minimum, depending
on I/O requirements)
❑
National Instruments 73xx series motion controller and associated
documentation
❑
One of the following National Instruments SHC68-C68-S cables
for connecting a motion controller to the UMI-7774/7772:
– 2 m (part number 186380-02)
– 0.5 m (part number 186380-0R5)
❑
Custom cable for connecting the UMI-7774/7772 to a third-party drive
❑
Third-party drive and documentation
ni.com/motion
2-1 National Instruments UMI-7774/7772 User Manual
2
.