Wall Mounting; 5A. Check Positions Of The Mountings; 5B. Assemble Mountings - Festo CPX Assembly Instructions Manual

5. Wall mounting

Information
In case of loads from vibration, shock or continuous shock with severity
level 1 ( tables in section 1), the mountings 5 are not required.

5a. Check positions of the mountings

Information
U V
18375d_34
Information
Mountings are pre-assembled, dependent on the configuration.
 Directly fasten VTSA/VTSA-F-modules (65 mm) ( section 5d).
 Check positions of the pre-assembled mountings ( tables) and correct,
if required ( section 5b).
Mounting 2 with CPX-modules (plastic)
Number of modules Mounting between the modules
2/3
−
1 ... 3
•
4 ... 5
6 ... 8 •
•
9 ... 10
Mounting 3 for CPX-modules (metal)
Number of modules Mounting to the modules
2
−
1 ... 3
4 •
5 ... 6
7
8
9 ... 10
Mounting 5 at VTSA/VTSA-F-modules (18 ... 52 mm)
Number of modules Mounting to the modules
1
1 ... 2 •
3 ... 5
6 ... 8
9 ... 12
13 ... 16
17 ... 20
, 20 Mounting 5 to every 4th module
3)
No additional mounting is required at a module directly next to the right end plate. Mount-
ing via the end plate is sufficient.
Counting direction of the mod-
ules:
CPX:
– from end plate (U).
VTSA/VTSA-F (18 ... 52 mm):
– from pneumatic inter-
face (V).
5/6 8/9
•
• •
3 4 6
•
•
• •
•
2 4 8 12
•
•
• •
• • •
• • •
3)
.

5b. Assemble mountings

Mounting 2 to CPX-modules (plastic)
2
18375d_4
Mounting 3 to CPX-modules (metal)
Information
For CPX-modules (metal) without system supply, the mounting 3 can be as-
sembled on both sides of the module.
3
B
7
18375d_14
Mounting 5 at VTSA/VTSA-F-modules (18 ... 52 mm)
6
3 Nm ± 20 %
•
5
C
16
•
18376d_4
 Press mounting 2 inclined
2
into the modules (A).
A
 Tilt mounting 2 until it
catches.
 Assemble additional mount-
ing 2 opposite.
 Place mounting 3 aligned
4
with the module (B).
1.5 Nm ± 10 %
 Tighten screws 4. If you
screw it in again, use the
threads already present.
Observe tightening torque.
 Place mounting 5 on the
module (C).
 Tighten screw 6. Observe
the tightening torque.
3