5D. Mount Vtsa/Vtsa-F-Modules (65 Mm) - Festo CPX Assembly Instructions Manual

5d. Mount VTSA/VTSA-F-modules (65 mm)

Information
W M
18373d_60
 Determine mounting points (M) ( table).
Mounting to VTSA/VTSA-F-modules (65 mm)
Number of modules Mounting with M8 screw to the modules
2
1 ... 2 −
•
3
4 ... 6
7 ... 9
10 ... 12
, 12 Mounting to every 3rd module
Information
If the mounting point (M) is covered:
 Remove module components.
 Fasten CPX-terminal 1 to the wall.
 Remount removed components.
Dismantling
18376d_21
4)
Mounting is not required to a module directly next to an end plate. Mounting via the end
plate is sufficient.
Counting direction of the mod-
ules:
VTSA/VTSA-F (65 mm):
– from adapter plate (W).
3 6 9
•
• •
• • •
4)
.
 Remove components until
the mounting point (M) is
freely accessible.
M
Alternative mounting
Assembly
3 Nm ± 20 %
3 Nm ± 20 %
18376d_22
1837
As an alternative to the mount-
6d_p
X
osr6
ing point (M), there is the op-
tion to fasten to the blind
hole (X) on the reverse side of
the modules.
 Determine mounting points
( table).
 Cut M8 thread into the blind
M
holes (X).
 Use M8 thread for mount-
ing.
 Mount components.
Observe tightening torques.
Check: Status and correct
position of the seals.
M
5