FireplaceXtrordinair ProBuilder 42 CleanFace Installation Manual page 73

Optional Equipment
4 Under each knock out plate, you will find a cover plate held in place with (2) ¼" screws. Use a nut driver
or drill with an extension to remove the (2) screws. Reach in and remove the cover plate. You may
discard the plates.
5 Insert a starter collar into each of the holes that were uncovered in the previous step and bend the tabs to
secure the starter collar to the fireplace.. Seal the joints with silicone caulk or aluminum (U.L. 181A-P)
tape
6 Install the fireplace into the framed chase. See section "Installation" in the manual.
© Travis Industries
(for qualified installers only)
4/22/21 - 1493
73
PB42 CF Install