Log Set Installation - FireplaceXtrordinair ProBuilder 42 CleanFace Installation Manual

52

Log Set Installation

Installation Warnings
NOTE: Consult the installation manual for order of installation. If using propane (LP), convert the appliance
before installing the log set. If using firebacks, install them prior to installing the log set.

The logs are fragile, especially after being exposed to heat.

Make sure the gas control valve is OFF and the heater is cool prior to installing logs.

Failure to position the parts in accordance with these diagrams or failure to use only parts specifically
approved with this appliance may result in property damage or personal injury.

The burner must be correctly positioned before installing the log set. Make sure the burner is fully seated
and the pilot is properly aligned. See owner's manual for details on burner removal.
Log Set Overview – GSR2 Model
The GSR2 version requires a log set (Oak = sku# 94500771, Birch = sku# 94500770). Instructions for installing
these logs are included with the logs.
Log Set Overview – MV/GSB2 Models
When installed, the (8) logs should appear as shown below. See the following pages for installation.
Log Name Rear Log
Replacement Part
250-05070
Number
Number on Back of
1
Log
Left Twig
250-05073
Left Log
250-05071
© Travis Industries
Installation
(for qualified installers only)
Left Log Right Log
250-05071 250-05072
2 3
Left Ember Chunk
250-05076
Right Front
Left Twig
Twig
250-05073 250-05074
4 5
Rear Log
250-05070
Right Ember Chunk
250-05077
4/22/21 - 1493
Right Rear Left Ember
Twig Chunk
250-05075 250-05076
6 7
Right Rear Twig
250-05075
Right Front Twig
250-05074
Right Log
250-05072
PB42 CF Install
Right Ember
Chunk
250-05077
8