FireplaceXtrordinair ProBuilder 42 CleanFace Installation Manual page 62

62
4. Install the LP pilot orifice following the instructions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then replace
the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
5. Reinstall the stock manifold covers.
MV Version
GSB2/GSR2
Version
© Travis Industries
Installation
(for qualified installers only)
4/22/21 - 1493 PB42 CF Install