Parts For Installation (Optional); Projected Image And Throw Distance - Panasonic PT-REZ80 Operating Instructions Manual

Hide thumbs Also See for PT-REZ80:
Table of Contents

Advertisement

Parts for installation (optional)

The projector can be installed on the ceiling by combining the optional Ceiling Mount Bracket (Model No.:
ET-PKD120H (for High Ceilings), ET-PKD120S (for Low Ceilings), ET-PKD130H (for High Ceilings, 6-axis
Adjustment)) and the Ceiling Mount Bracket (Model No.: ET-PKD130B (Projector Mount Bracket)).
f Be sure to use the Ceiling Mount Bracket specified for this projector.
f Refer to the Installation Instructions of the Ceiling Mount Bracket when installing and setting up the projector.
Attention
f To ensure projector performance and security, installation of the Ceiling Mount Bracket must be carried out by your dealer or a qualified
technician.

Projected image and throw distance

Install the projector referring to the projected image size, projection distance, etc.
Attention
f Before setting up, read "Precautions for use" (x page 24).
f Do not use the projector and the high-powered laser equipment in the same room. The DLP chips can be damaged if a laser beam hits the
projection lens surface.
Figure of projected image and throw distance
Note
f This illustration is prepared on the assumption that the projected image size and position have been aligned to fit full in the screen.
f This illustration is not in accurate scale.
SH
SW
SD
H
L
(LW/LT)
*1
*2
L1
*1 For details about calculating the projection distance, refer to "Formula for calculating the projection distance per projection lens" (x page 50).
*2 LW: Minimum projection distance when the Zoom Lens is used
LT: Maximum projection distance when the Zoom Lens is used
44 - ENGLISH
Chapter 2 Getting Started — Setting up
Projected image
SW
Projected image height
Projected image width
Projected image size
Distance from the lens center to the bottom edge of the projected image
Projection distance (distance from the front end of the projection lens to the screen)
Lens protrusion dimension (distance from the front surface of the projector to the front end of the projection
lens)
Screen
L (LW/LT)
L (LW/LT)
Screen
L1
L1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pt-rez12Pt-rez10

Table of Contents