Advertisement
Available languages
Available languages
inside the motor moving against each
other. The function of the power tool
is not affected by this. We do however
recommend not to use the power tool
near any flammable liquids, gases or
dust, which the sparks may ignite.
Mounting drill/driver bits
Before any work on the machine (e.g.
maintenance, tool change, etc) as
well as during transport and storage,
set rotational direction switch to
the centre position. Unintentional
actuation of the trigger can lead to
injuries.
Adjust the chuck until the opening is
slightly larger than the shaft of the
drill bit that you wish to use. Insert
the drill bit into the chuck. Tighten the
chuck against the drill as described
below (Keyless chuck).
Regulating the shaft speed
It is possible to regulate both shaft
speeds from zero to maximum by
altering the pressure applied to the
trigger. This enables you to choose the
optimum speed for the task you are
working on. Use the lower speed for
tightening/loosening screws (position
1 on the gear selector (3)).
Selecting shaft speed
Use a low speed when starting to drill
in metal, plastic or ceramic materials,
using the screwdriver function or
carrying out work that requires a high
degree of torque. Use a high speed
when drilling in wood (position 2 on
the gear selector (3)).
Reversing the direction of rotation
You can reverse the direction of
rotation by using the rotational
direction switch (4).
To lock the trigger, set the selector to
the mid position between the right
and left options.
Adjusting the tightening moment
Turn the torque regulator (2) to the
desired position. Settings 1-19 are
used for tightening/loosening screws
(the higher the value, the greater
the tightening moment). Select the
drill symbol before using the tool for
drilling.
Keyless chuck
Your drill has a keyless chuck so that
you can simply tighten or release drill/
driver bits.
To open/close the chuck hold the rear
ring (10) and rotate the front sleeve
(11).
WARNING:
RISK OF TRAPPING
Do not hold the front sleeve of the
chuck with one hand at the same time
as you open or close the jaws of the
chuck with the help of the screwdriver/
drill's motor.
11
Advertisement
