Advertisement
Available languages
Available languages
lights up while the battery is being
charged (7).
Under normal conditions of use the
screwdriver/drill can be recharged
several hundred times.
ATTENTION!
The recharging process generates
heat in the battery.
Note: The battery that is supplied with
the screwdriver/drill has been charged
for test purposes only and must be
fully recharged before first time use.
First read the safety instructions and
then follow the loading instructions.
Insert the transformer plug into the
socket in the screwdriver/drill. Then
connect the charger's transformer to
the electricity supply.
Make sure that there are no knots or
sharp bends in the cable.
The charger's transformer and the
battery have been designed to be
used together.
NEVER use this charger to recharge
cordless tools or batteries from
other manufacturers. The battery will
gradually lose its charge over a period
of time, even if the tool is not used.
The lithium-ion battery is protected
against deep discharging by the
"Electronic Cell Protection (ECP)".
When the battery is empty, the
machine is switched off by means of a
protective circuit: The inserted tool no
longer rotates.
WARNING
Do not continue to press the On/Off
switch after the machine has been
automatically switched off. The battery
can be damaged.
WARNING!
Recharge the battery on a non-
flammable surface. Do not recharge
the battery for more than eight hours.
The red diode will turn green when the
battery has been fully loaded.
Disconnect the cable and store the
transformer in a suitable place when it
is not in use.
It is not advisable to recharge the
battery in temperatures below
freezing.
INSTRUCTIONS FOR USE
Using the tool
Note: Sparks may be visible through
the slots in the motor housing during
operation. The sparks are a normal
reaction of the motor when in use
and are created by the components
10
Advertisement
