Table of Contents
Advertisement
by moving the start upwards to
position MIST
upon exceeding the 5 km/h speed with
the rain sensor
Deactivation
Through the display Menu or the
Uconnect™ system, or by rotating ring
nut (A) to any non-intermittent position
( or ).
REAR WINDOW WIPER /
WASHER
Activation
The ring nut (B) can be set to the
following positions:
rear window wiper stopped
intermittent operation
continuous operation, without
pausing between the two strokes
By operating ring nut (B), the rear
window wiper can function in the
following modes:
continuous: when the ring nut is in
position
intermittent: when the ring nut is
in position and the screen wiper is
stopped
synchronous: when the ring nut is in
position and the screen wiper is moving
or set to AUTO.
In this mode, the rear window wiper
makes one stroke for each two strokes of
the screen wiper;
single stroke: when the ring is in the
position, the windscreen wiper is active
and reverse gear is engaged.
Push the stalk towards the dashboard
(rocking position) to activate the rear
window washer jet. Keep pushing the
lever to automatically activate both the
rear window washer jet and the rear
window wiper with a single movement.
Deactivation
The function stops when the stalk is
released.
WARNING
21) Make sure the device is turned off
whenever the windscreen glass must be
cleaned.
IMPORTANT
7) Never use the screen wiper to remove
layers of snow or ice from the windscreen
glass. In such conditions, the windscreen
wiper may be subjected to excessive
stress and the motor cut-out switch,
which prevents operation for a few
seconds, may intervene. If operation is
not subsequently restored, even after
restarting the engine, contact a Jeep
Dealership.
8) Do not operate the screen wiper with
the blades lifted from the windscreen
glass.
9) Do not activate the rain sensor when
washing the car in an automatic car wash.
10) Make sure the device is switched off
if there is ice on the windscreen glass.
33
Advertisement
Table of Contents
