Table of Contents
Advertisement
68) Do not tamper or perform any
operations in the area of the windscreen
glass directly surrounding the sensor.
69) Clean the windscreen glass from
foreign matters such as bird droppings,
insects, snow or ice. Use specific
detergents and clean cloths to avoid
scratching the windscreen.
INTELLIGENT SPEED
ASSIST
(where provided)
The system can be used to set a speed
limit equal to that indicated on the
road sign detected by the "Traffic Sign
Recognition" system (see the respective
paragraph in this chapter for more
information), indicated to the driver by
means of an indication on the instrument
panel.
The maximum speed can be set both
with car stationary and in motion.
The minimum speed that can be set is
30 km/h.
SPEED LIMIT PROGRAMMING
The system can be activated if the driver
has activated the systems beforehand:
Speed Limiter
Traffic Sign Recognition
162
A message indicating that a speed
limit switch to that detected by the
Traffic Sign Recognition system can be
programmed with these systems active.
If the speed is higher than the current
speed level stored by the Speed
Limiter, message
will appear on the
instrument panel.
If the speed shown by the Traffic
Sign Recognition is lower than the
current speed level stored by the Speed
Limiter, message
will appear on the
instrument panel
SYSTEM ACTIVATION
To activate the system, press the RES
button on the steering wheel (see "Speed
Limiter" paragraph in this chapter), to
store the speed limit equal to the one
indicated by the Traffic Sign Recognition
system.
The activation of the system is
indicated by the
symbol on the
instrument panel (green on versions with
reconfigurable multifunction display).
The system is deactivated under
the following conditions:
when the Traffic Sign Recognition
system is deactivated;
when the Speed Limiter system is
deactivated;
when the Traffic Sign Recognition
system shows a new speed limit;
when the Traffic Sign Recognition
system shows the end of the speed limit;
when the Traffic Sign Recognition
system cannot display any speed limit.
EXCEEDING THE PROGRAMMED
SPEED
By fully depressing the accelerator pedal,
the programmed speed can be exceeded
even with the system active (e.g. in the
event of overtaking).
The system is disabled until the speed
drops below the set limit, after which it
activates again automatically.
Advertisement
Table of Contents
