Table of Contents
Advertisement
When a USB device is inserted with the
radio on, it starts to play the tracks on
the device if the "AutoPlay" is set to
"ON" in the "Audio" menu.
AUX source
(where provided)
To activate AUX mode, insert an
appropriate device in the AUX socket in
the car. When a device is inserted using
the AUX output socket the system starts
reproducing the AUX source connected,
if it is already being played.
Adjust the volume using the VOLUME
button/knob on Uconnect™ front panel or
using the volume adjustment control on
the connected device.
The "AUX Volume Offset" function can be
selected in "Audio" settings only when
the AUX source is active.
IMPORTANT NOTES
The functions of the device connected
with the AUX socket are directly
managed by the device itself: it is not
possible to change track/folder/playlist
or control playing start/end/pause with
the controls on the front panel or on the
steering wheel.
To avoid possible speaker noise, do not
leave the cable of the portable reader
connected to the AUX socket after
disconnection.
PHONE MODE
Phone mode activation
Press the "Phone" button on the display
to activate the Phone mode.
NOTE To consult the list of mobile
phones and supported functions, visit
the www.driveuconnect.eu website
Use the buttons on the display to:
dial the phone number (using the
graphic keypad on the display);
display and call the contacts in the
mobile phone phonebook;
display and call contacts from the
registers of previous calls;
pair up to 10 phones/audio device to
make access and connection easier and
quicker;
transfer calls from the system to
the mobile phone and vice versa and
deactivate the microphone audio for
private conversations.
The mobile phone audio is transmitted
through the vehicle's audio system; the
system automatically mutes the radio
when the Phone function is used.
Pairing a mobile phone
WARNING Carry out this operation
only with car stationary and in safety
conditions; this function is deactivated
when the car is moving.
The pairing procedure for a mobile phone
is described below: always consult the
handbook for the mobile phone in any
case.
To pair the mobile phone, proceed as
follows:
activate the Bluetooth® function on the
mobile phone;
press the "Phone" button on the
display;
if no phone is paired with the system
yet, the display shows a dedicated
screen;
access "Settings" and select "Add
device" to start the pairing procedure,
then search for the Uconnect™ device on
the mobile phone;
when prompted by the mobile phone,
use its keypad to enter the PIN code
shown on the system display or confirm
on the mobile phone the PIN displayed;
during the pairing stage a screen is
displayed showing the progress of the
operation;
305
Advertisement
Table of Contents
