Wake Up The Ev (Evse With Display); Stop A Charge Session; Evse With An Ev Charge Cable; Evse With A Socket - ABB Terra AC User Manual

Operation
4.5.2

Wake up the EV (EVSE with display)

Preliminary requirements
Procedure
1. Disconnect the EV charge cable from the EV.
2. Connect the EV charge cable to the EV again.
4.6

Stop a charge session

4.6.1

EVSE with an EV charge cable

1. Select one of the two ways to end the charge session.
•
•
2. Disconnect the EV charge cable from the EV.
3. Wrap the EV charge cable around the enclosure. Refer to section 4.7.
4.6.2

EVSE with a socket

36
1. The display shows that the EV is not ready for the charge session.
Caution: During the charge session, do not disconnect the EV charge
cable from the connector on the EV. There is a risk of damage of the
connector of the EV.
Note: If you disconnect the EV charge cable during the charge session,
the EVSE automatically disconnects the power supply. This stops all
charging operations.
Wait until the charge session is completed.
ChargerSync app shows that the charge session is completed.
• The
• The charging LED is on.
• If your EVSE has a display, the display shows that the charge session is
completed.
When the charge session is completed, the EVSE disconnects the power
supply automatically.
Authorize the ending of the use of the EVSE with your RFID card or the
ChargerSync app. The authorization of the disconnection to the EV starts.
Caution: During the charge session, do not disconnect the EV charge
cable. There is a risk of damage of the socket of the EVSE or the
connector of the EV.
Note: If you disconnect the EV charge cable during the charge session,
the EVSE automatically disconnects the power supply. This stops all
charging operations.
BCM.V3Y00.0-EN | 002