Project Properties Dialog - Ir Emitters And Receivers Tab - AMX MIO-R4 Operation/Reference Manual

TPDesign4 Project Files

Project Properties dialog - IR Emitters and Receivers tab

Use the options in the IR Emitters and Receivers tab (FIG. 25) to view/edit port information associated
with the active panel file for AMX 38KHz IR emitting and receiving, AMX 455KHz IR emitting and
receiving, and up to two user-defined ports for IR emitting using custom IR files.
FIG. 25 Project Properties dialog - IR Emitters and Receivers tab
This tab is only present if the target panel selected for this project supports an IR emitter or an IR
receiver.
The options that are available in this tab depend on the IR capabilities of the target touch panel for this
project. For example, the Modero CV7 panel has an IR receiver, but does not have an IR emitter. In this
case, the only fields that are enabled in this tab would be the AMX IR Receivers (38KHz and 455KHz)
fields, where you could specify a channel port assignment for either 38KHz or 455KHz IR reception.
The NXD/T-CV7 have AMX IR receivers, and the MVP-7500 and MVP-8400(i) have AMX and User-
defined IR emitters, as well as a cradle sensor.
The options in this tab include:
Project Properties dialog - IR Emitters and Receivers tab
• AMX IR Emitters
(MVPs only):
• AMX IR Receivers
(CV7 and CV10s
only):
• User IR Emitters
(MVPs only):
• Additional User
IR Emitters
(MVP-5220 &
MVP-5200i only)
28
These options allow you to specify the IR Channel port (either 38KHz or 455KHZ) to be
used for standard AMX IR emitting for MVP-7500 and MVP-8400(i) panels.
These options allow you to specify the IR Channel port (either 38KHz or 455KHZ) to be
used for AMX IR receiving for NXD/T-CV7 and NXD/T-CV10 panels.
These options allow you to specify the IR Channel port (either 38KHz or 455KHZ) to be
used for user-defined IR emitting for MVP-7500 and MVP-8400(i) panels.
These options allow you to use up to six additional IR Emitters (for a total of 8 IR
Emitters) with the panel. The User IR Emitters table displays a grid of user IR ports
(Ports column) and their respective IR Channel Port values (Value column) in two col-
umns:
TPDesign4 Touch Panel Design Software (v2.10 or higher)