Working With Dynamo Video; Setting Up A Dynamo Video Image - AMX MIO-R4 Operation/Reference Manual

Working With the Resource Manager
To allow other users to access the files via FTP without password protection, leave
the User and Password fields blank. The user must type either "Anonymous" or
"Guest" to access the specified FTP site.

Working With Dynamo Video

Dynamo is an extension of the Dynamic Images feature of AMX G4 devices.
With the growing popularity of Motion JPEG (or M-JPEG), streaming being adopted by leading
manufacturers of video equipment, DynaMo now enables the use of this technology in AMX systems.
The setup process is essentially identical to that for setting up other Dynamic Images. It includes three
easy steps:
1. Create a Dynamic Image in TPDesign4 project.
2. Create a General button the Dynamic Image will be displayed on.
3. Select the Dynamic Image in the button's Bitmap properties.

Setting Up a DynaMo Video Image

1. In TPDesign4 software, create a new project (or open an existing project in which you would like to
add DynaMo video). Open Resource Manager, go to the Dynamic Images tab, and click on New to
create a new Dynamic Image (FIG. 86):
FIG. 86 Creating a Dynamic Image - Step 1
196
Connection: Use these options to specify the protocol and URL information.
Refresh Rate: Use the up/down arrows to adjust the number of seconds between refreshes in
which the resource is downloaded again. Refreshing resources will cause the button
displaying that resource to refresh as well. The default value is 0, which means that the
resource is only downloaded once.
Refresh only at Panel Startup: This option is only available if the Refresh Rate is set to zero,
and causes the dynamic image to refresh only upon restart of the panel, as opposed to upon
each visit to the page (as is the default).
TPDesign4 Touch Panel Design Software (v2.10 or higher)