Mio Modero IR
Wiring and Installation
Set the receive AxLink device number before installing the Mio Modero IR. FIG. 12 illustrates the
location of key components on the Mio Modero IR circuit board.
Screw
holes
FIG. 12
Location of key components on the Mio Modero IR circuit board
Setting the AxLink Device Number
1. If connected, disconnect the power supply.
2. Locate the 8-position Device DIP switch (FIG. 12).
3. Set the DIP switch according to the DIP switch values shown below.
The device number is set by the total value of DIP switch positions that are ON (up).
As an example, the DIP switch in FIG. 13 defines device number 129 (1+128=129).
FIG. 13
Example Device DIP Switch set to 129
If you later change the device number, remove and reconnect the AxLink power connector to enter the
new device number into memory.
16
AxLink
3.5 mini Phoenix
connector
PWR+
8 position mini
DIP switch
Notch to pry
faceplate free
(Rear Single)
Switch
1 2 3 4 5
Value
1 2 4 8 16 32 64 128
6
7
8
Mio Modero Device Family